INSTRUCTIONS FOR CARCAPSULE SETUP

1.  Select your place of set up by considering the following:

A.  Place the fan end nearest to the electrical source.
B.  The air intake should be away from outside doors and heat sources.
C.  The surface should be as flat as possible.
D.  The basemat should be located with all sides accessible to work the zippers.

2.  Insert the fan panel into position, smooth out the Velcro.

3.  Push the male connector through the slit in the basemat.  Connect the male end to the female end connector of the fan motor.

4.  Starting at the fan end, carefully drape the clear center section over the vehicle's hood, roof and trunk.  Zip both zippers closed securing the tops and sides. 

5.  Plug the 12V transformer into your wall outlet and your CarCapsule will start to inflate.  After the bubble is completely inflated, insert the filter by pushing the brim inside the flap around the fan.

6.  To increase airflow thru the cover to dry wet vehicles or to regulate the air pressure in extremely hot weather, simply readjust the rear zipper closure to allow more air to flow through the capsule.  On the average the CarCapsule will change its air volume 3 to 4 times per hour.

7.  For the Silver Outdoor Model:  The outdoor model has tie-downs to prevent movement of your bubble in the wind.  The loops for the tie-downs are located on each side of your bubble. Also you will find a 3.5" plastic strip that you must insert inside fan shroud. (LOOK FOR BELT LOOPS) This will give the pouch form to insert the filter. Next you will find a 1" vinyl strip with velcro on both ends that attaches under filter to keep in place.

A.  Attach a string to an eyelet on the top of the bubble.  Tie a secure knot.
B.  For extra securing, slide a pole into the loops at the top of the Outdoor Capsule before Step A.
C.  If you wish to attach bubble to ground.  Drive a stake into the ground at a forty-five degree angle away from your bubble.  Attach the string to the stake.  Repeat A and C on other side of your bubble.  Stakes are not included and can be purchased from your local hardware store.

CARE INSTRUCTIONS FOR CARCAPSULE

1.  The clear unit is for indoor use only.  The silver unit is for outdoor use.

2.  Do not put any material under the floor section, it will only trap moisture!  This can create mold or mildew.

3.  Locate the air intake filter away from outside doors or sources of heat such as water heaters, furnaces, roll-up metal doors or washer/dryers.

4.  Keep the air filter clean by hand washing in warm water.  You may use a mild dish soap if necessary.

5.  Do not place any source of heat inside the cover (not even a light bulb).

6.  If CarCapsule is first used in extremely cold climates, blow up in a warm area to help PVC become pliable.

7.  When you set up your CarCapsule for the first time, it will have a lot of wrinkles.  As it is kept inflated, the remainder of the wrinkles will work themselves out.

8.  If your CarCapsule gets dusty you can use a car duster.  To remove stains, use warm water and a mild dish soap.

MANUFACTURER'S GUARANTEE

The CarCapsule is guaranteed for one year against all defects in workmanship and materials. Repair or replacement will be made upon receipt of product by CarCapsule freight prepaid. Please contact the place of purchase prior to shipping for warranty work.